
CARE AND CLEANING
Clean the appliance after each use.
Always use cookware with clean bottom.
Scratches or dark stains on the glass-
ceramic cause no effect on how the
appliance operates.
To remove the dirt:
1. – Remove immediately: melted plas-
tic, plastic foil, and food with sugar. If
not, the dirt can cause damage to
the appliance. Use a special scraper
for the glass . Put the scraper on the
glass surface at an acute angle and
move the blade on the surface .
– Remove after the appliance is
sufficiently cool: limescale rings ,
water rings, fat stains, shiny metallic
discolorations. Use a special cleaning
agent for glass ceramic or stainless
steel.
2.
Clean the appliance with a moist cloth
and some detergent.
3.
At the end rub the appliance dry
with a clean cloth.
TROUBLESHOOTING
Problem Possible cause Remedy
You cannot activate the appli-
ance or operate it.
Activate the appliance again
and set the heat setting in less
than 10 seconds.
You touched 2 or more sensor
fields at the same time.
Touch only one sensor field.
There is water or fat stains on
the control panel.
Clean the control panel.
The appliance deactivates. You put something on the sen-
sor field
.
Remove the object from the
sensor field.
The residual heat indicator
does not come on.
The cooking zone is not hot
because it operated only for a
short time.
If the cooking zone operated
sufficiently long to be hot,
speak to the service centre.
The sensor fields become hot. The cookware is too large or
you put it too near to the con-
trols.
Put large cookware on the rear
cooking zones if necessary.
comes on.
The Automatic Switch Off oper-
ates.
Deactivate the appliance and
activate it again.
comes on.
No cookware is on the cook-
ing zone.
Put cookware on the cooking
zone.
The cookware is incorrect. Use the correct cookware.
The diameter of the bottom of
the cookware is too small for
the cooking zone.
Move cookware to a smaller
cooking zone.
and a number come on.
There is an error in the appli-
ance.
Disconnect the appliance from
the electrical supply for some
time. Disconnect the fuse from
the electrical system of the
house. Connect it again. If
comes on again, speak to the
service centre.
8
Comentários a estes Manuais